ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Biology
Research
Architecture and Urbanism
Medicine / Sub specialtie
Agronomy and forestry
Education
Technology
Social Sciences
Public health
Pure sciences
all records (73)

Languages
English
Spanish
Portuguese
German
French

Countries
Indonesia
USA
Brazil
Ukraine
India
South Africa
Canada
Spain
Romania
Poland
all records (80)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
14.697  Articles
1 of 1.471 pages  |  10  records  |  more records»
In this work, we investigated the effect of carbon and nitrogen on the hardness and electrochemical properties of titanium Ti6Al4V. Thin films of titanium nitride (TiN) and titanium carbide (TiC) were deposited by radio frequency (RF) sputtering to invest... see more

First of all, it was necessary to replace flat products from high-alloy ??67???? and 06?15?6???? with one alloy that would possess the necessary set of physicomechanical characteristics. In the work, as a replacement for the used heat-resistant alloys, th... see more

In this work, we investigated the effect of carbon and nitrogen on the hardness and electrochemical properties of titanium Ti6Al4V. Thin films of titanium nitride (TiN) and titanium carbide (TiC) were deposited by radio frequency (RF) sputtering to invest... see more

Nickel matrix composite coatings with ceramic disperse phase have been widely investigated due to their enhanced properties, such as higher hardness and wear resistance in comparison to the pure nickel. The main aim of this research was to characterize th... see more

The present work deals with preparation of Fe3Si coatings on mild steel and evaluation of its magnetic property and corrosion behavior. Magnetic property of coatings was measured using a vibrating sample magnetometer, the result shows that the saturation ... see more

This contribution deals with evaluation of the corrosion resistance of extruded Mg-2Al-1RE (AE21) magnesium alloy in the state before and after treatment of ground surface by selected phosphatizing procedure. Specimens were exposed to 0.1M NaCl solu... see more

The main aim of this work is to monitor the surface treatment impact on the corrosion resistance of the welded stainless steel AISI 316L to local corrosion forms. The excellent corrosion resistance of austenitic stainless steel is caused by the existence ... see more

Cr–Si–O–N coatings with different oxygen contents were deposited by multi-arc ion plating, where various O2/(N2 + O2) reactive gas rates were adopted. The XRD and XPS results showed that the CrN crystals disappeared with the increasing of the oxygen flux ... see more

The corrosion resistance of homogenized Al-Mg (6.5%) alloy—adding Si, Zn, Mn, and Fe (0.2%) to improve various properties—was observed. Differential scanning calorimetry (DSC) and a JMatPro simulation revealed that the optimal homogenization temperature w... see more

1 of 1.471 pages  |  10  records  |  more records»