ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Technology
Biology
Education
Agronomy and forestry
Pure sciences
Research
Physical
Environment
Industrial engineer
Chemistry
all records (72)

Languages
English
Spanish
Portuguese
German
French

Countries
Indonesia
USA
Brazil
Ukraine
Pakistan
Russia
Portugal
Argelia
Chile
Turkey, Turkish Republic
all records (72)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
18.625  Articles
1 of 1.863 pages  |  10  records  |  more records»
This study uses multivariate adaptive regression spline (MARS) for determination of maximum shear modulus (Gmax) and minimum damping ratio (?min) of synthetic reinforced soil. MARS employs confining pressure (s, psi), rubber (r, %) and sand (s, %) as inpu... see more

Increasing demands of reinforcement in the joint panel are now requiring more effective system to reduce the complicated fabrication by widely used precast system. The joint panel is responsible to keep the load transfer through beam and column as a cruci... see more

Tef (Eragrostistef (Zucc.)Trotter) is atypical crop growing in most areas of Ethiopia, with the first area coverage. In this study mechanical properties of Tef stem the major four varieties, viz;  Local, Dz-Cr-438- (Kora), Dz-Cr-387/RIL-355(Quncho) a... see more

 Improve quality of timber structures design is an aim that must be systematically sought by engineers in this area. An important topic that can contribute directly to be achieved in this subject is the more consistent knowledge related to structural... see more

Representative evaluation of soil response requires the input parameters to be close to the physical behavior of soil column in the site. Several site response studies are carried out worldwide, considering limited representative parameter of stiffness of... see more

 Improve quality of timber structures design is an aim that must be systematically sought by engineers in this area. An important topic that can contribute directly to be achieved in this subject is the more consistent knowledge related to structural... see more

A steel shear modulus measurement has been conducted using spring-mass oscillation analysis. The purpose of this study is to determine whether the spring-mass oscillation analysis method can measure the shear modulus of the steel. In this study, springs t... see more

The lay-up of cross laminated timber (CLT) leads to significant differences in properties over its cross-section. Particularly the out-of-plane shear behavior of CLT is affected by the changes in shear moduli over the cross-section. Results from laborator... see more

The estimation of the soil seismic response at the surface can be made by several experimental methods, approximate and numerical. This study consists in using numerical simulation to determine the surface response in terms of maximum acceleration and res... see more

1 of 1.863 pages  |  10  records  |  more records»