ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Education
Technology
Social Sciences
Economy
Research
Architecture and Urbanism
Languages
Literature
Pure sciences
Industrial engineer
all records (73)

Languages
English
Spanish
Portuguese
German
French
Finnish

Countries
Indonesia
USA
Brazil
Ukraine
South Africa
Austria
Italy
United Kingdom
Cuba
Germany
all records (76)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
44.164  Articles
1 of 4.417 pages  |  10  records  |  more records»
With modern production, Minimum Quantity Lubricant (MQL) technology has emerged as an alternative to conventional liquid cooling. The MQLs is an environmentally friendly lubricant method with low cost while meeting the requirements of machining conditions... see more

The results of experimental studies of acoustic radiation energy during processing tool wear are considered. The regularities of acoustic emission signal statistical energy parameters changes at normal and catastrophic processing tool wear are determined.... see more

In the present study, experimental research was carried out to determine the effect of the processing tool wear on the mutual change in the average statistical amplitude parameters of acoustic emission signals. Acoustic emission signals were recorded when... see more

This study aims to investigate tools wear and wear mechanisms when machining high-rate extreme minimum lathe AISI 4140 material in hard and dry cutting conditions. Cutting tool made from CBN CB7015 Sandvik Coromant production is used for turning of AISI 4... see more

Reduction of machining times and optimization of cutting parameters and conditions hold great importance in machining processes. Milling is among the most important machining processes used for machining of fiber-reinforced composite materials. The presen... see more

Lithic use-wear analysis has become a principal approach for interpreting the function of stone tools and inferring human behaviour. This study presents the results of use-wear analysis on lithic tools excavated from the Upper Paleolithic sites of Xiachua... see more

The need for machining advanced materials has increased exponentially in recent years. Ni-based alloys, Ti-based alloys or some steel grades are commonly used in transport, energy generation or biomedicine industries due to their excellent properties that... see more

Tribological phenomena and tool wear mechanisms during machining of hard-to-cut TiAl6V4 aerospace alloy have been investigated in detail. Since cutting tool wear is directly affected by tribological phenomena occurring between the surfaces of the workpiec... see more

In this study, the wear mechanisms and tribological performance of uncoated and coated carbide tools were investigated during the turning of super duplex stainless steel (SDSS)—Grade UNS S32750, known commercially as SAF 2507. The tool wear was evaluated ... see more

1 of 4.417 pages  |  10  records  |  more records»