7 articles in this issue
Ali A Aljubouri
The die geometry has a massive effect on the plastic deformation behavior during pressing of material processed by equal channel angular pressing (ECAP) method; subsequently the properties of the processed material are strongly dependent on it. Two ... see more
Mohd Fo'ad Rohani, Mohd Aizaini Maarof, Ali Selamat, Houssain Kettani
This paper proposes a Multi-Level Sampling (MLS) approach for continuous Loss of Self-Similarity (LoSS) detection using iterative window. The method defines LoSS based on Second Order Self-Similarity (SOSS) statistical model. The Optimization Method (OM) ... see more
Abiodun Musa Aibinu, M.J.E. SALAMI, A.A. SHAFIE
The use of vascular intersection as one of the symptomsfor monitoring and diagnosis of diabetic retinopathy fromfundus images have been widely reported in literatures. Inthis work, a new hybrid approach that makes use of threedifferent methods of vascular... see more
Muhammad Abid
In this paper result of an extensive comparative experimental study of a gasketed and non-gasketed flange joint with different assemblies with different combined load combinations is carried out to investigate joint performance i.e. joint strength and sea... see more
Muhammad Abid, Adnan Aslam Noon, Hafiz Abdul Wajid
Tarbela dam is one of the largest earth filled dam in the world. The sediments inflow in the Tarbela reservoir has resulted in reduction in water storage capacity. During the recent years, a reasonable increase of sediment particles in the tunnel is obser... see more
Nur Ayuni jamal
Composites based on high density polyethylene (HDPE), ethylene propylene diene monomer (EPDM) and organophilic montmorillonite (OMMT) clays were prepared by melt compounding followed by compression molding. The addition of clay as well as compatibilizer a... see more
Tanay Dey, M.M.A. Hashem, Subroto Kumar Mondal
Due to mobility of nodes in ad hoc networks, the most challenging issue is to design and to make sound analysis of a routing protocol that determines its robustness to deliver packets in low routing packet overhead. In this paper, we thoroughly analyzed t... see more