ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Education
Technology
Economy
Social Sciences
Architecture and Urbanism
Research
Languages
Literature
Industrial engineer
Pure sciences
all records (73)

Languages
English
Spanish
Portuguese
German
French
Finnish

Countries
Indonesia
USA
Brazil
Ukraine
South Africa
Cuba
Italy
Spain
Germany
United Kingdom
all records (75)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
45.521  Articles
1 of 4.553 pages  |  10  records  |  more records»
Specimens made of Vanadis 6 steel were heat treated, plasma nitrided and coated with Cr2N. The microstructure, phase constitution and mechanical properties of plasma nitrided areas and duplex-coatings have been investigated using the light micro... see more

Cr- and Cr-V ledeburitic cold work tool steels belong to the most important tool materials for large series manufacturing. To enable high production stability, the tools must be heat treated before use. This overview paper brings a comprehensive study on ... see more

Gross cracking of die-casting dies with inferior toughness sometimes occurs through too low preheating temperature and/or too slow cooling during quenching. This study aimed to clarify the influence of cooling rate on the toughness of the hot-work tool st... see more

The difficulties in the machining of duplex stainless steel are well known. However, research on this matter is rather limited. Suppliers offer quite different cutting tools for the same raw material, with end mills of two, three or even four knives and a... see more

In this study, the wear mechanisms and tribological performance of uncoated and coated carbide tools were investigated during the turning of super duplex stainless steel (SDSS)—Grade UNS S32750, known commercially as SAF 2507. The tool wear was evaluated ... see more

With modern production, Minimum Quantity Lubricant (MQL) technology has emerged as an alternative to conventional liquid cooling. The MQLs is an environmentally friendly lubricant method with low cost while meeting the requirements of machining conditions... see more

In automated manufacturing systems, most of the manufacturing processes, including machining, are automated. Automatic tool change is one of the important parameters for reducing manufacturing lead time. Machining studies on Martensitic Stainless Steel wa... see more

In the machining of metal cutting, cutting tools are the main things that must be considered. Using improper cutting parameters can cause damage to the cutting tool. The damage is Built-Up Edge (BUE). The situation is undesirable in the metal cutting proc... see more

There search of cutting tools from different supplier to establish their responsibility with thees sential requirements was conducted in the work. Metal-cutting tools of  the domestic instrumental works (taken as the standard through certification in... see more

1 of 4.553 pages  |  10  records  |  more records»