ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Education
Construction engineering
Architecture and Urbanism
Civil Engineering
Social Sciences
Industrial engineer
Research
Pure sciences
Technology
Infrastructure
all records (74)

Languages
English
Spanish
German
Portuguese
Finnish
French

Countries
Indonesia
Brazil
USA
Ukraine
Chile
Spain
Argelia
South Africa
Denmark
Switzerland
all records (76)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
7.754  Articles
1 of 776 pages  |  10  records  |  more records»
 In this paper, four concrete frame joints with high-strength stirrups and one with normal-strength stirrups were tested to investigate the mechanical properties of concrete beam-column joints with high-strength stirrups under low cyclic reversed loa... see more

The use of precast concrete modular construction in the replacement and rebuilding of old structures has recently increased. However, the joints between modules in this type of construction exhibit special behavior that should be considered when analyzing... see more

Passenger and freight traffic on our roads continues to increase in number and severity. High axle loads, high tyre pressures and greater dynamic loads require load-bearing and stable road pavements. Concrete road pavements are highly suitable for meeting... see more

The paper describes the development and construction for concrete pavements of short slabs with fiber incorporated in roads at international level, from its origins as a reinforcement layer and the new slab design methodology with optimized geometry as an... see more

A smooth cold joint of concrete is an untreated weak plane caused by an interruption of the casting process, which can significantly affect the performance of a structural system. In this paper, the problem of the generation of cold joints is approached f... see more

This paper briefly describes a global methodology to develope incremental equations for pavement distress prediction,which are very useful to evaluate in-service pavements. Such methodology is subsequently applied to model transverse jointfaulting in conc... see more

Three partially pre-stressed interior beam-column sub-assemblages (SI) and two partially pre-stressed exterior beam-column sub-assemblages (SE) made of reactive powder concrete as test specimens were numerically modeled using a finite element program. The... see more

Ultra-high-performance concrete (UHPC) has been introduced for reinforced concrete structures due to its enhanced mechanical performance, including high compressive strength and tensile capacity. In certain applications, such as closure joints, connection... see more

A large share of reinforced concrete (RC) framed buildings is provided with wide beams being a type of beam allowing greater freedom in the architectural arrangement of interiors, beyond further advantage due to fewer formworks needed during the construct... see more

1 of 776 pages  |  10  records  |  more records»