ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Mechanical Engineering
Industrial engineer
Technology
Construction engineering
Pure sciences
Economy
Civil Engineering
Architecture and Urbanism
Physical
Infrastructure
all records (71)

Languages
English
Spanish
German
Portuguese
French

Countries
Indonesia
USA
Brazil
Ukraine
Lithuania
Chile
Denmark
Russia
Argelia
South Africa
all records (72)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
4.589  Articles
1 of 460 pages  |  10  records  |  more records»
One of the main considerations in adopting the additive manufacturing (AM) technology is whether the material properties of the AM-produced part are comparable with the wrought material. This study compared the properties of AM-produced 304 stainless stee... see more

One of the main considerations in adopting the additive manufacturing (AM) technology is whether the material properties of the AM-produced part are comparable with the wrought material. This study compared the properties of AM-produced 304 stainless stee... see more

Abstract: In this study, waterjet peening (WJP) treatments under different water pressures were utilized to improve the mechanical properties of 304 stainless steel. The surface morphologies, microstructures, phases, and mechanical properties under differ... see more

In this research, the analysis of corrosion rate and hardness on stainless steel 304 and lateritic nickel steel in corrosive medium has been done. The lateritic nickel steel used has different Ni content of 0, 3, 4, 6, and 10%. The corrosion rate was calc... see more

The change of protective current density, the formation and growth of calcareous deposits, and the evolution of passive film on 304 stainless steel (SS) were investigated at different potentials of cathodic polarization in sea water. Potentiostatic polari... see more

The focus of today’s machining industry is on how to maintain high productivity and low cost achieved by high tool life during the operation. Laser cutting is considered the right solution because it offers cutting speeds of up to 170000 mm/min through a ... see more

Penelitian ini bertujuan untuk mengetahui nilai kekerasan dan struktur mikro hasil lasan sambungan las TIG pada stainless steel AISI 304 dengan penggunaan variasi jenis filler. Metode yang digunakan adalah metode eksperimental untuk membuktikan adanya per... see more

The aim of this study was to develop a composite coating on 304 stainless steel employing a TIG (tungsten inert gas) process. Ti wire cored with graphite powder was used as the means of coating material. The process parameters were controlled to develop a... see more

Tangki merupakan wadah penyimpanan yang sering dipakai di berbagai industriseperti petrokimia, pengilangan, dan perminyakan. Tangki penyimpanan tidak hanya menjadi tempat penyimpanan untuk produk dan bahan baku tetapi juga menjaga kelancaran ketersed... see more

1 of 460 pages  |  10  records  |  more records»