ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Mechanical Engineering
Technology
Chemistry
Pure sciences
Industrial engineer
Agronomy and forestry
Biology
Research
Environment
Food and nutrition
all records (68)

Languages
English
German
Spanish
Portuguese

Countries
Indonesia
USA
Brazil
Ukraine
Lithuania
India
Switzerland
Russia
Argelia
Italy
all records (61)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
1.986  Articles
1 of 200 pages  |  10  records  |  more records»
Closed-cell aluminum alloy (A356) foams with different percentages of Al-Ti-B are prepared by melt foaming method, using Ca and TiH2 as thickening agent and foaming agent, respectively. SEM and Quasi-static compression tests are performed to investigate t... see more

Macrostructure has an important effect on the compressive properties of closed-cell aluminum foams. Meanwhile, the decomposition behavior of a foaming agent has a significant influence on the macrostructure of closed-cell aluminum foams. In order to get o... see more

In this paper, a comprehensive literature review is presented regarding dynamic progressive buckling analyses of foam-filled hat section columns. The results obtained from a numerical simulation were in good agreement with the theoretical predictions. Rem... see more

The casting process and cooling rate determine the morphology of the authentic silicon particles produced in aluminum alloys. The slow cooling rate of aluminum alloy through the Lost Foam Casting (LFC) method a result of low mechanical properties. The pur... see more

The analysis of aluminum scrap processing technologies is presented taking into account the economic and environmental components. Acid-alkaline methods sulfate and soda methods, as well as electric arc remelting of aluminum slag in a single-phase AC elec... see more

Abstract—In this study, the aluminum foam material having two different pore structures was obtained. These materials were cut using advanced cutting methods (waterjet and wire erosion). And then, the porosity levels of the cut surfaces were examined de... see more

Solid foams have been intensely studied as promising structured catalytic internals. However, mechanisms governing flow and transport phenomena within the foam structures have not been properly addressed in the literature. The aim of this study was to con... see more

In this paper the authors propose a new damage accumulation modelbased on an exponential approach for aluminum closed cell foam underfully reversed cyclic loading. The model developed need as an input, theinformation about the fatigue behavior of the mate... see more

Surface contact explosion experiments were performed to study the dynamic behaviour of concrete sandwich panel subjected to blast loading. Experimental results have shown that there are four damage modes explosion cratering, scabbing of the backside, radi... see more

1 of 200 pages  |  10  records  |  more records»