ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Technology
Biology
Agronomy and forestry
Industrial engineer
Chemistry
Pure sciences
Food and nutrition
Physical
Environment
Mechanical Engineering
all records (73)

Languages
English
Spanish
German
Portuguese
Finnish
French

Countries
Indonesia
USA
Ukraine
Russia
Brazil
India
Lithuania
Turkey, Turkish Republic
Italy
Romania
all records (73)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
24.586  Articles
1 of 2.460 pages  |  10  records  |  more records»
This manuscript presents the research on the machining properties of kumpang (Albizia sp.) wood, in particular wood surface smoothnes, which were tested at two moisture contents, 14% and 10 %, respectively. Machining properties was tested according to the... see more

There have been very few reports describing the free machining lead free aluminum alloys containing minimal amounts of tin and indium melt spun process. Our paper describes the effect of fundamental factors on the machinability of free machining lead free... see more

The Al 6070 is the side plate material of the MTR-fuel plate bundle. These post-irradiation mechanical properties will be used in the side plate cutting process to obtain certain plates from the MTR-fuel plate bundle. This activity is part of a series of ... see more

The Al 6070 is the side plate material of the MTR-fuel plate bundle. These post-irradiation mechanical properties will be used in the side plate cutting process to obtain certain plates from the MTR-fuel plate bundle. This activity is part of a series of ... see more

The increasing number of materials with variation in properties, especially hard-to-cut, leads to the need for an advanced machining method to process such material. Electric Discharge Machining (EDM) is one of the advanced machining methods widely used f... see more

The increasing number of materials with variation in properties, especially hard-to-cut, leads to the need for an advanced machining method to process such material. Electric Discharge Machining (EDM) is one of the advanced machining methods widely used f... see more

This article presents test results of the machining properties  of 36 wood species from  Manokwari,  lrian Jaya.  The test method used was the modified  ASTM D-1666 described in Forest Products  Research Institute Report No.1... see more

The machining properties of  34 wood  species  tested according to the ASTMD 1666-64  procedure are presented in this paper.  The machining  properties studied  were planing,  shaping,  turning,  sanding,&... see more

The quality of machining properties of nine wood  species, i.e. gawil  (Mangifera altissima Blanco.); sana  (T erminalia  bellerica Roxb.); jinarti  (Symplocos brandisii  Ket   V.) ;  tunjang  gunung ... see more

1 of 2.460 pages  |  10  records  |  more records»