ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Technology
Industrial engineer
Chemistry
Pure sciences
Physical
Mechanical Engineering
Mathematics
Environmental engineering
Electrical and electronic

Languages
English

Countries
USA
Lithuania
Indonesia
Ukraine
Malaysia

Years
2023
2018
2017
2016
2015
2014
2013
2012
2004

Filter  
 
19  Articles
1 of 3 pages  |  10  records  |  more records»
This work reports on a very effective route to produce bio-based polyurethanes (PUs) and composites with high content of renewable carbon sources. The PUs are prepared with polyols synthesized from macauba oil (Acrocomia aculeata) and methylene diphenyl d... see more

A number of polymeric glues based on linseed oil, animal hide and hydroxy-terminated polybutadiene (HTPB)-derived polyurethanes have been synthesised. These glues are sticky in natureand characterised by viscosity, FTIR spectra and adhesive strength. Thes... see more

The present study investigates the dynamic mechanical (DMA) properties of condensation nonisocyanate polyurethanes (NIPUR) containing different hard segments (HS) content. NIPUR films were prepared by reacting phenol sulfonic acid with urea and formaldehy... see more

Amide and ester type polyols were synthesized from rapeseed, sunflower and castor oils, and two types of ethanolamine (diethanolamine and triethanolamine) at different molar ratio. Poly(urethane amides) and polyester urethanes based on the synthesized pol... see more

Amide and ester type polyols were synthesized from different kinds of tall oil and two types of ethanolamine (diethanolamine and triethanolamine). Poly(urethane amides) and polyester urethanes based on the synthesized polyols were prepared. The influence ... see more

The dielectric and relaxation properties of cross-linked polyurethane, modified with heteropolynuclear Cu3Mn(L4) complexes with various ligands in outer coordination sphere were analyzed by dielectric relaxation spectroscopy. It was shown, that the modifi... see more

Abstract: In this study, we have fabricated a series of polycarbonate polyurethanes using a two-step bulk reaction by the melting pre-polymer solution-casting method in order to synthesize biomedical polyurethane elastomers with good mechanical behavior a... see more

The most commonly used materials in the production of high-performance CFs are cellulose, polyacrylonitrile, and pitch. Polyacrylonitrile (PAN)-based fibers dominate the market (representing nearly 90% of total CF production), with some companies producin... see more

A thin layer of liner is applied to ensure a good bond between the insulator and the propellant in case-bonded rocket motors. It also acts as a protective shield for the insulatorby providing a limited fire protection effect. Liner compositions should pre... see more

1 of 3 pages  |  10  records  |  more records»