ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Industrial engineer
Technology
Geology
Environment
Mechanical Engineering
Biology
Oceanography
Medicine / Dentistry
Research
Education
all records (61)

Languages
English
Spanish

Countries
Indonesia
USA
Brazil
Lithuania
Ukraine
Chile
India
United Kingdom
Spain
Pakistan
all records (45)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
432  Articles
1 of 44 pages  |  10  records  |  more records»
Putri Island, Nongsa is the outer and frontier island of NKRI region bordering Singapore. Its existence is very important both economically and politically. The management of  Putri Island should consider the coastal characteristic that describes cha... see more

Abrasion injuries result in damage only to the surface layer of skin and can result in player discomfort and changes in performance. The perceived fear of abrasion injuries on artificial turf playing surfaces has significantly affected the adoption of the... see more

The current study mainly investigated the influence of different tests on the abrasion resistance of concrete mixed with steel fibers and silica fume. The abrasion resistance was assessed at 28, 56 and 91 days on concretes with water-binder ratios of 0.35... see more

Experimental dental composite materials were obtained using urethane aliphatic dimethacrylate monomers (isophorone diisocyanate 2-hydroxyethyl methacrylate) and Bis GMA respectively as organic phase. Glass containing barium oxide and colloidal silica, and... see more

Objective: To compare the effects of air abrasion and high speed diamond bur on the topography of cavity preparations and the microleakage on primary teeth.Methods: in this in vitro study, the cavities were prepared on the occlusal surfaces of 60 tee... see more

The effect of abrasive shape on the three-body abrasion behaviors of monocrystalline silicon was investigated via molecular dynamics. The axial ratio of abrasive particle varied from 1.00 to 0.40 to mimic abrasive shape. It has been observed that the part... see more

Thermally-sprayed alumina based materials, e.g., alumina-titania (Al2O3-TiO2), are commonly applied as wear resistant coatings in industrial applications. Properties of the coatings depend on the spray process, powder morphology, and chemical composition ... see more

Surface coatings formed by immersion in the ionic liquids (ILs) 1,3-dimethylimidazolium methylphosphonate (LMP101), 1-ethyl-3-methylimidazolium methylphosphonate (LMP102) and 1-ethyl-3-methylimidazolium ethylphosphonate (LEP102) on magnesium alloy AZ31B a... see more

In this research, effects of fine aggregate abrasion resistance and its fineness module on wear resistance of Portland cement concrete pavements studied. Concrete samples included fine crushed limestone aggregate, fine crushed limestone-basalt mixture, an... see more

1 of 44 pages  |  10  records  |  more records»