ARTICLE
TITLE

VIBROSTABILITY IMPROVEMENT USING THE ACTIVE CLAMP IN MACHINING

SUMMARY

In this paper the results of simulation of vibration suppression during machining are presented. Two versions of the active clamp system were examined. In the case when the work-piece vibration dominates one direction, the active clamp system with 1 degree of freedom (1-DOF) can be used. Also, a 2-DOF sys-tem is proposed to show the effectiveness of the active clamp system for a complex vibration scenario.

KEYWORDS

 Articles related

Krzysztof Jan Mazur,Marek Pawelczyk    

Active Noise Control (ANC) systems are usually designed in the feed-forward structure with adaptive linear control filters. However, performance of such systems, when a vibrating plate is used as the secondary source, may be poor due to significant non-l... see more


Zdzislaw Gosiewski    

Collocation of sensors and actuators is an important feature of all motion control systems of active structures. Collocated systems provide great advantages from a stability, passivity, robustness and an implementation viewpoint. However it is not always... see more


Michal Kozupa,Jerzy Wiciak    

The paper is an analytical and experimental study of smart structure, which consist of steel plate with bonded PZTs and porous elastomer layer. Active control of sound radiation from a clamped at the edge square plate is examined. Simulations and numeric... see more


Stanislaw Wrona,Marek Pawelczyk    

For successful active control of a vibrating structure it is essential to appropriately place sensors. One of the most important criteria is to make the system observable, so any control objectives can be achieved. In this paper the observability-oriente... see more


Dariusz Grzybek    

The ability to damp vibrations is important in many structures, in which trusses are one of the main elements. The increase of the damping of the truss vibrations is possible by passive means or by the use of an active vibration control system integrated... see more