8 articles in this issue
Jurnal Konversi Energi dan Manufaktur Editor's
SUMMARY. Rohmatin et al., in their paper, identified the movements that occur when using a portable study table and analyzed indications of user posture risks that could be experienced when utilizing a portable study table. Wahyudi and Kusuma, in their pa... see more
Teguh Wahyudi, Yuriadi Kusuma
Steam power plant (PLTU) is one type of energy conversion technology to generate electricity from fossil materials. The performance of a PLTU unit will begin to decline as the unit ages. In addition to age, performance degradation can also be caused by de... see more
Alsen Medikano, Anissa Aprilya, Nur Aini Azisah
Since the occurrence of the Covid-19 pandemic in early 2020 in Indonesia, it has been necessary to maintain the body's immunity so that it remains stable so that the body is not easily exposed to the virus. For that, PT Karya Bahana Unigam needs to do som... see more
Andre Ryan Prasetyo, Sulis Yulianto, Edi Widodo
Until now, the process of processing paddy into rice still relies heavily on the traditional and commonly used methods. During the drying stage, the harvested rice grains are spread out and sun dried. To address this issue, an effective solution is needed... see more
Ragil Sukarno, Muhammad Fajar Ramadhan , Farezi Andriansyah, Yudha Adigutama, Syamsuir, Hari Sampurno
The acidity and turbidity of water are essential factors in tilapia farming, so it is necessary to control the acidity (pH) and turbidity (NTU) of water. This research aims to develop an automatic water recirculation system to save the use of clean water ... see more
Agus Wijianto, Fajar Alfitrah
The development of energy is very important to maintain oil reserves and also substitute for fossil fuels. Agricultural waste can be used as an alternative raw material to assist in the depletion of petroleum reserves and increase the use value of agricul... see more
Yakobus Rhio Widodo, Gian Villany Golwa
The demand to improve quality and productivity in the manufacturing industry underlies the analysis of tool deformation rates in the turning process. The methods used previously are considered inaccurate, and the provided information is incomplete. Theref... see more
Ulin Nuha, Gian Villany Golwa
In the machining process, knowledge of the tool and workpiece is required to achieve maximum results between quality and productivity. Tool wear parameters are very important to know because the process of changing or sharpening the tool can be predicted.... see more