ARTICLES

Filter  
Active filters 0
Remove
  

Refine your searches by:

Collections
Technology
Education
Economy
Pure sciences
Computing
Research
Computing
Mechanical Engineering
Industrial engineer
Architecture and Urbanism
all records (72)

Languages
English
German
Spanish
Portuguese

Countries
Indonesia
USA
Ukraine
Brazil
Switzerland
Russia
Italy
Argelia
Chile
Austria
all records (75)

Years
2023
2022
2021
2020
2019
2018
2017
2016
2015
2014
all records (24)

Filter  
 
19.382  Articles
1 of 1.939 pages  |  10  records  |  more records»
The numerical spectral wave generation and propagation model WAVAD was used to derive the wave climate over 19 years at four locations in the southern Baltic Sea, namely in the Pomeranian Bay, and outside the Polish, Lithuanian, and Latvian coasts. One-, ... see more

Numerical modeling of flood flow and the evaluation of flood hazards can be based on various numerical models and modeling techniques. One-dimensional (1D), quasi two-dimensional (1,5 D), two-dimensional (2D) or three-dimensional (3D) variants of numerica... see more

Debris flow is a disaster occurring in cases where a sediment particle flows at high speed, down to the slope, and usually with high viscosity and speed. This disaster is very destructive and human life-threatening, especially in mountainous areas. As one... see more

This paper presents a study of the behavior of reinforced concrete continuous deep beams by numerical simulation, where results of the numerical analysis are calibrated and validated from existing experimental results in the international literature. In t... see more

In this paper, we present the model equation of a beam when it applies compression forces on ends of the beam and carries a load. From the structural point of view, there should be a suitable model to understand the behavior under different conditions of ... see more

There was a tendency in recent decades to increase the combustion temperature in gas-turbine engines (GTE). This allows increasing both the efficiency of the engine and the output power. In modern engines, the temperature of the exhaust gas is already sig... see more

There was a tendency in recent decades to increase the combustion temperature in gas-turbine engines (GTE). This allows increasing both the efficiency of the engine and the output power. In modern engines, the temperature of the exhaust gas is already sig... see more

The aim of this paper is to evaluate the quality of high-resolution weather forecasts from the Weather Research and Forecasting (WRF) numerical weather prediction model. The lateral and boundary conditions were obtained from the numerical output of the Co... see more

Three partially pre-stressed interior beam-column sub-assemblages (SI) and two partially pre-stressed exterior beam-column sub-assemblages (SE) made of reactive powder concrete as test specimens were numerically modeled using a finite element program. The... see more

1 of 1.939 pages  |  10  records  |  more records»